Error: Src Refspec Master Does Not Match Any [how To Fix]
error: src refspec master does not match any [How To Fix] A lot of people are confused when they run into this error, or at least I was. Deep down inside, it’s simple: it means there is a mismatch between the source refspec that you set in your repository and the one that’s listed on Github.
In this article we’ll walk through how to fix this error message so you can get back up and running as fast as possible!
error: src refspec master does not match any
>The git push command fails with the following error message:
>error: src refspec master does not match any
>failed to push some refs to [FIX]
error: failed to push some refs to [FIX]
In the output, you’ll see the following error:
“`
error: failed to push some refs to [FIX]
“`
error: src refspec master does not match any anything
It’s a common error message that appears when you try to push your code to the remote repository. It looks like this:
error: src refspec master does not match any anything
error: failed to push some refs to [FIX]
error: src refspec master does not match any [How To Fix]
error: src refspec master does not match any [How To Fix]
- Check the refspec.
- Check the remote.
- Check the remote ref.
- Check the remote refspec.
- Check the remote refspec master. If you’ve already done this and everything seems to match, but it still says “remote refspec master does not match any”, try this next:
Message ‘src refspec master does not match any’
If you have tried to push your code with git push and received the following error message:
src refspec master does not match any
error: src refspec master does not match any
error: failed to push some refs to [remote]
You can fix this by following the steps below.
git push error: src refspec main does not match any on linux
git push error: src refspec master does not match any on linux
How do I fix error SRC Refspec master does not match any?
Here are some ways to fix the error:
- git push origin master
- git push origin master:master
- git push origin master -f
- git push origin master -f –force
Conclusion
We hope that all of these tips and tricks will help you get over the hump of this particular error message. As always, if you have any other suggestions or ideas on how to fix this issue, feel free to reach out in the comments!
ncG1vNJzZmiZnKG0rbvBmqOuqJSWwaa%2FjZympmeVp7%2BwvoysqZxlopqztLzEnGSmmaOpsrN5w6icrGWepMFuucCtmqFlkaPGcA%3D%3D